subject
Engineering, 10.07.2021 01:10 ghkfkhgm859

Q6. The frame is made from pin-connected members, and is supported by pins at point A and C. The frame is subjected to a uniformly distributed load with load
intensity w = 209 lb/ft, and the lengths are 11 = 3.0 ft and 12 = 5.1 ft. The horizontal
member AB is a hollow square pipe, and it has the cross section as shown, with outer
dimension do - 2.2 in, and inner dimension d; = 1.7 in. Determine the magnitude of
maximum bending stress at point D, in the unit of ksi.
W
k do
D
B
di
1.5 ft
A
E
4 ft
2.5 ft
11
12


Q6. The frame is made from pin-connected members, and is supported by pins at

point A and C. The

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
question
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
question
Engineering, 04.07.2019 18:10
Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines
Answers: 1
question
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
You know the right answer?
Q6. The frame is made from pin-connected members, and is supported by pins at point A and C. The fr...
Questions
question
Mathematics, 15.01.2021 18:40
question
English, 15.01.2021 18:40
question
Mathematics, 15.01.2021 18:40