subject
Engineering, 08.07.2021 09:20 samarkanduzbek

Q.1 / A shaft is loaded in bending and torsion such that M. = 600 lbf. in , T. = 400 lbf. in , Min = 500 lbf in , and Tm = 300 lbfin. For the shaft , S. = 100 kpsi and S , = 80 kpsi, and a fully corrected endurance limit of Se = 30 kpsi is assumed. Let k , = 2.2 and Ks = 1.8 . With a design factor of 2.0 determines the minimum acceptable diameter of the shaft using the (a) DE - Gerber criterion . (b) DE - elliptic criterion. (c) DE - Soderberg criterion. ( d ) DE Goodman criterion . Discuss and compare the results .

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
question
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
question
Engineering, 04.07.2019 19:20
The quality is zero at a)-the saturated vapour state b)-the saturated liquid state c)-the saturated liquid-vapour mixture state d)-none of the states in the other answers
Answers: 3
question
Engineering, 05.07.2019 19:10
Tech a says never use a water hose to clean up dust after a repair. tech b says never use a floor scrubber to clean up dust after repairs. who is correct?
Answers: 1
You know the right answer?
Q.1 / A shaft is loaded in bending and torsion such that M. = 600 lbf. in , T. = 400 lbf. in , Min =...
Questions
question
English, 04.11.2019 01:31
question
Mathematics, 04.11.2019 01:31