Engineering, 12.06.2021 15:40 TerronRice
In a chemical blanking operation, the stock thickness of an aluminum sheet is 0.015 in. The pattern to be cut out of the sheet is a hole pattern, consisting of a matrix of 0.100 in diameter holes. If photochemical machining is used to cut these holes, and contact printing is used to make the resist (maskant) pattern, determine the diameter of the holes that should be used in the pattern.
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
Engineering, 04.07.2019 19:10
The proportional limit is always greater than the yield strength for a material. a)-trune b)- false
Answers: 3
You know the right answer?
In a chemical blanking operation, the stock thickness of an aluminum sheet is 0.015 in. The pattern...
Questions
Biology, 01.08.2019 04:00
History, 01.08.2019 04:00
Biology, 01.08.2019 04:00
Mathematics, 01.08.2019 04:00
History, 01.08.2019 04:00
Mathematics, 01.08.2019 04:00
Mathematics, 01.08.2019 04:00
Mathematics, 01.08.2019 04:00
Biology, 01.08.2019 04:00
History, 01.08.2019 04:00
Social Studies, 01.08.2019 04:00
