Engineering, 12.06.2021 14:00 lamontcarter
For the servo system shown in figure (2). Design the compensator (Gc(s)) to meet the specifications of natural frequency (ωn=5) and damping ratio (ζ=0.2).​
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
Engineering, 04.07.2019 18:20
How much power could a wind turbine produce if it had the following specifications? cp = 0.45 -d=1.2kg/m3 d=50m v 5m/s
Answers: 2
Engineering, 04.07.2019 19:20
Acircular pipe of 30mm outside diameter is placed in an airstream at 30 c and latm pressure. the air moves in cross flow over the pipe at 20 m/s, while the outer surface of the pipe is maintained at 110 c. what is the drag force exerted on the pipe per unit length? what is the rate of heat transfer from the pipe per unit length?
Answers: 1
Engineering, 06.07.2019 04:10
Aheat pump that operates on the ideal vapor compression cycle with refrigerant-134a is used to heat water from 15°c to 45°c at a rate of 0.12 kg/s. the condenser and evaporator pressures are 1.4 and 0.32 mpa, respectively determine: (a) the power input to the heat pump
Answers: 1
For the servo system shown in figure (2). Design the compensator (Gc(s)) to meet
the specifications...
Chemistry, 05.01.2021 05:50
English, 05.01.2021 05:50
History, 05.01.2021 06:00
Health, 05.01.2021 06:00
Mathematics, 05.01.2021 06:00
Social Studies, 05.01.2021 06:00
Mathematics, 05.01.2021 06:00
Mathematics, 05.01.2021 06:00
Mathematics, 05.01.2021 06:00