Engineering, 09.06.2021 22:50 jesse1384
A strut is made up by rigidly joining two 140 mm x 60 mm x 16.2 kg/m taper flange channels
rigidly joined to form a rectangular tube section, 6 m long. The strut may buckle due to an axial
compressive load. The pin-fixed end supports may be assumed for buckling about the stronger
axis but fixed-fixed end supports may ​
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
Engineering, 04.07.2019 18:20
Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms
Answers: 2
Engineering, 04.07.2019 18:20
Inspection for bearing condition will include: (clo4) a)-color b)-smell c)-size d)-none of the above
Answers: 1
Engineering, 04.07.2019 18:20
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
You know the right answer?
A strut is made up by rigidly joining two 140 mm x 60 mm x 16.2 kg/m taper flange channels
rigidly...
Questions
Mathematics, 10.11.2020 05:00
Mathematics, 10.11.2020 05:00
Social Studies, 10.11.2020 05:00
Chemistry, 10.11.2020 05:00
Mathematics, 10.11.2020 05:00
Health, 10.11.2020 05:00
Mathematics, 10.11.2020 05:00
Mathematics, 10.11.2020 05:00
Mathematics, 10.11.2020 05:00
Mathematics, 10.11.2020 05:00
Arts, 10.11.2020 05:00
Mathematics, 10.11.2020 05:00
Arts, 10.11.2020 05:00
