Engineering, 08.06.2021 22:00 insulation62
Which option identifies the next step Kristin should take to test the design in the following scenario?
During the design process, Kristin determined that her new automatic-loading pencil sharpener is ready to be tested. She is still concerned that there may need to be some changes before the prototype is created.
She should create a prototype that is flexible enough to make changes to if needed.
She should create a two-dimensional sketch to ensure she has not missed any information.
She should make any changes she feels are necessary before designing a model.
She should create a model using cutting-edge technology programs.
Answers: 3
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature
Answers: 2
Engineering, 04.07.2019 18:10
A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.
Answers: 2
Which option identifies the next step Kristin should take to test the design in the following scenar...
Mathematics, 09.09.2021 01:00
History, 09.09.2021 01:00
History, 09.09.2021 01:00
Biology, 09.09.2021 01:00
Mathematics, 09.09.2021 01:00
Mathematics, 09.09.2021 01:00
History, 09.09.2021 01:00
Social Studies, 09.09.2021 01:00