subject
Engineering, 03.06.2021 16:20 tyryceschnitker

Steam flows steadily through an adiabatic turbine. The inlet conditions of the steam are 4 MPa, 500C, and 80 m/s, and the exit conditions are 92 percent quality, and 50 m/s. The mass flow rate of the steam is 12 kg/s. Investigate the effect of the turbine exit pressure on the power output of the turbine. Let the exit pressure vary from 10 to 200 kPa (10 different pressure namely 10, 30, 40, 50, 75, 100, 125, 150, 175, 200 kpa is enough). Prepare a table and two plot as follows:
• Tabulate turbine exit pressure, the power output of the turbine and turbine exit temperature (the table template is below)
• Plot the power output against the exit pressure,
• Plot the exit temperature against the exit pressure,
• and discuss the results

Not: The red ones my answers but I'm not really sure about them.


Steam flows steadily through an adiabatic turbine. The inlet conditions of the steam are 4 MPa, 500

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 14:10
Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.
Answers: 3
question
Engineering, 03.07.2019 19:30
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
question
Engineering, 04.07.2019 18:10
The higher the astm grain size number, the finer the gran is. a)-true b)-false
Answers: 2
question
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
You know the right answer?
Steam flows steadily through an adiabatic turbine. The inlet conditions of the steam are 4 MPa, 500C...
Questions
question
Mathematics, 03.05.2021 22:40
question
Physics, 03.05.2021 22:40
question
Mathematics, 03.05.2021 22:40
question
Engineering, 03.05.2021 22:40
question
Mathematics, 03.05.2021 22:40