Engineering, 03.06.2021 16:20 veritoburito

Steam flows steadily through an adiabatic turbine. The inlet conditions of the steam are 4 MPa, 500C, and 80 m/s, and the exit conditions are 92 percent quality, and 50 m/s. The mass flow rate of the steam is 12 kg/s. Investigate the effect of the turbine exit pressure on the power output of the turbine. Let the exit pressure vary from 10 to 200 kPa (10 different pressure namely 10, 30, 40, 50, 75, 100, 125, 150, 175, 200 kpa is enough). Prepare a table and two plot as follows:
• Tabulate turbine exit pressure, the power output of the turbine and turbine exit temperature (the table template is below)
• Plot the power output against the exit pressure,
• Plot the exit temperature against the exit pressure,
• and discuss the results

Steam flows steadily through an adiabatic turbine. The inlet conditions of the steam are 4 MPa, 500

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

Answer

Engineering, 04.07.2019 19:10

The short distance from the objective lens to the object causes problems at high magnification. which of the following is the most serious? a. cleaning the object surface b. positioning the object c. reflection from the object surface. d. illumination of the object

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer,e = 5 × 105?

Answers: 2

Answer

You know the right answer?

Steam flows steadily through an adiabatic turbine. The inlet conditions of the steam are 4 MPa, 500C...

Questions