Engineering, 30.05.2021 15:40 tbt81

You are sketching the layout of a residential rooftop PV system to share with your installation team. Place these system components in the correct order by entering the corresponding letters with no punctuation or spaces. Use all components listed below. Note: Two of these components are not specifically labeled in the associated video lesson, but should be readily identifiable. You can begin and end on either end of the system- both answers will be scored correct. A. Utility
B. AC Disconnect Switch
C. Grid-Tie Inverter
D. Utility Distribution Meter
E. DC Disconnect Switch
F. Breaker Box
G. REC Generation Meter
H. Solar PV Modules

You are sketching the layout of a residential rooftop PV system to share with your installation tea

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

Answer

You know the right answer?

You are sketching the layout of a residential rooftop PV system to share with your installation team...

Questions