subject
Engineering, 24.05.2021 04:30 naomiedgrey

Dant را
salallal
Kinematics of Particle
.6 PROBLEMS INVOLVING KINEMATIC OF PARTICLES
1 An athletic champion runs at a speed of 5m/s. On hitting the ropes at the finishing
line, he starts decelerating at a constant rate of 1.3m/s2. Calculate how long it
takes him to stop and how far from the finishing line.
2 A pressurized wine bottle is opened by force and the cork shoots into the air vertically
It takes 15s to rise to its highest position. What is the velocity with which it lef
the bottle?
3 Calculate the constant acceleration required for a car starting from rest to reach
velocity of 20 m/s in 30 s.
A motorcycle accelerates at 3m/s2. It is required to attain a velocity of 100km/hr ove
a distance of 0.3km. Calculate the initial velocity of the motorcycle.
A car starting from rest accelerates at 2.5m/s2 for the first 20 s of its journey. It
then brought to a stop in another 30 s with a uniformly decreasing velocity. Wh
is the total distance travelled?​

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
question
Engineering, 04.07.2019 03:10
What precautions should you take to prevent injuries when dealing with heavy loads?
Answers: 1
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
You know the right answer?
Dant را
salallal
Kinematics of Particle
.6 PROBLEMS INVOLVING KINEMATIC OF PARTICLES...
Questions
question
Mathematics, 30.08.2019 18:30