Engineering, 21.05.2021 07:30 Fatoucham1200
Drawing and Geometry: Sketching Exercise
The ability to transfer 3D Information back to a 2D world of drawings is key for these professions, Break a bullding down in
components geometrically. Draw the front elevation (front face of the building, write a summary that indicates which bull
what the building is used for. Provide a complete address (this will help the instructor assess your work). Then step back an
the entire building from all sides and angles. All design begins with geometry.
Question #1
File Upload
Write a summary that indicates which building it is and what the building is used for.
Submit your work.
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
Engineering, 04.07.2019 18:10
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
Engineering, 04.07.2019 18:10
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
Engineering, 04.07.2019 18:20
Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.
Answers: 2
You know the right answer?
Drawing and Geometry: Sketching Exercise
The ability to transfer 3D Information back to a 2D world...
Questions
Computers and Technology, 31.10.2019 03:31
