subject
Engineering, 18.05.2021 15:50 makiahlynn3642

Stereolithography is to be used to build the part in Figure below. Dimensions of the part are shown in detail. The laser beam diameter = 0.175mm, and the beam can be moved across the surface of the photopolymer at = 600mm/s. Layer thickness = 0.15mm. Compute an estimate of the time required to build the part, if 8s are lost each layer to lower the height of the platform that holds the part. Neglect post-curing time.


Stereolithography is to be used to build the part in Figure below. Dimensions of the part are shown

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
question
Engineering, 04.07.2019 18:10
Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines
Answers: 1
question
Engineering, 06.07.2019 02:30
Around steel bar, made from material with a yield stress of 750mpa, is loaded so that it has stresses co locations of maximum normal stress and maximum shear stress. use maximum shear stress and maximum distortion energy theories to calculate the safety factors for initial yielding failures.
Answers: 3
question
Engineering, 06.07.2019 03:10
List and describe the parts of boxford cnc milling machine with pictures?
Answers: 2
You know the right answer?
Stereolithography is to be used to build the part in Figure below. Dimensions of the part are shown...
Questions
question
Mathematics, 12.04.2021 04:10
question
German, 12.04.2021 04:20