subject
Engineering, 17.05.2021 20:20 bettybales1986

Halp please. After you helped me with filling the table, answer these questions

- Based on your comparisons, which solution would you recommend and why? Write a short paragraph of 4-8 sentences. Provide at least two reasons to support your decision.


Halp please.

After you helped me with filling the table, answer these questions
- Based on your c
Halp please.

After you helped me with filling the table, answer these questions
- Based on your c
Halp please.

After you helped me with filling the table, answer these questions
- Based on your c

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
question
Engineering, 04.07.2019 18:10
Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.
Answers: 3
question
Engineering, 04.07.2019 19:10
A)-in the process of engineering design, explain the contribution of material selection. b)- explain the procedure of synthesis as is employed in engineering design. c)- is there any relationship between ergonomics and engineering design? explain. d)- safety consideration in engineering design includes human, product and the enviroment . explain how safety will be incorporated into the design?
Answers: 3
question
Engineering, 04.07.2019 19:10
Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.
Answers: 1
You know the right answer?
Halp please. After you helped me with filling the table, answer these questions

- Based...
Questions
question
Mathematics, 23.12.2020 20:30
question
Mathematics, 23.12.2020 20:30
question
Mathematics, 23.12.2020 20:30
question
Mathematics, 23.12.2020 20:30
question
Spanish, 23.12.2020 20:30