Engineering, 13.05.2021 17:30 asaadasaadasaad6524

A helical coil compression spring is needed for food service machinery. The load varies from a minimum of Fmin 6 lbf to a maximum of Fmax 20 lbf. The spring rate k is to be 9.5 lbf/in. The outside diameter of the spring cannot exceed 2.5 in. The spring maker has available suitable dies for drawing 0.08-in-diameter wire. Use a fatigue design factor nfof 1.5 and the Gerber-Zimmerli fatigue-failure criterion. NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. Determine the values for each of the following for a value of 0.08 in:
The torsional modulus of rupture, Ssu, is 160.544 kpsi.
Torsional yield strength, Ssy is 85.527 kpsi.
The endurance strength, assuming unpeened spring wire, Sse, is 39.452 kpsi.
The value of the mean diameter, D, is 0.66 in.
The alternating shear stress, Ta is 21.50 kpsi.
The fatigue factor of safety, nf, is 1.3 .
The free length, Lo, is 4.75 in.
The critical length, Lo(cr), is 2.5 in.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 16:10

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

Answer

Engineering, 04.07.2019 18:10

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

You know the right answer?

A helical coil compression spring is needed for food service machinery. The load varies from a minim...

Questions