Engineering, 08.05.2021 01:00 vsuescun10

A coil spring in an oscillating machine runs at between 500 and 1500 rpm (cycles per minute). The spring diameter is 50 mm and the wire diameter is 4 mm. The free length of the spring is 200 mm and the solid length is 80 mm. The ends are squared and held between flat, parallel plates. The spring is made of hard-drawn steel wire. Based on comparing the critical frequency and the range of operating frequencies, is this a good design? Given: For the specific weight of steel, use 77,000 N/m
a. Calculate the number of active coils, Na.
b. Calculate the approximate spring rate, k.
c. Calculate the weight of the spring, W.
d. Calculate the lowest critical frequency, f in cycles per second.
e. Is this an acceptable design?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Answers: 2

Answer

Engineering, 04.07.2019 18:10

What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

Answer

Engineering, 04.07.2019 19:10

How to increase the thermal officiency of an ideal simple rankino cycle? among these methods, which one is the best and why?

Answers: 2

Answer

You know the right answer?

A coil spring in an oscillating machine runs at between 500 and 1500 rpm (cycles per minute). The sp...

Questions