Engineering, 07.05.2021 16:00 bneilesauger

A solid steel spindle shaft of circular cross section is to be used to support a ball bearing idler pulley. The inner raceof the ball bearing is attached to the fixed non-rotating shaft. The rotating pulley is attached to the outer race of the ball bearing. The bearing is single-row 02-series deep-groove. Based on the preliminary stress analysis of the shaft, it must have at least a 1.63 inches outside diameter. The Weibull parameters are x0= 0.020, theta=4.459,and b = 1.483. The following information is given for your calculation. a) Calculate the catalog rating C10for the ball bearing(10 points)
b) Select the smallest acceptable bearing (bore)from Table 11-2(5 points)
c) If the selected ball bearing in b) is usedfor this application, estimate the reliability of the selected ball bearing.(10 points)

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

True or false (explain) (110)[111] is a slip system in bcc metals . the {111} family in fcc contains 8 planes. resolved shear stress (rss) in single crystals is just related to the applied stress. critical resolved shear stress (crss) in single crystal metals is direct proportional to the number of defects in the structure

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

Engineering, 06.07.2019 02:30

Air (c-1.006 kj/kg.k, r-0.287 kj/kg.k) enters a nozzle steadily at 280 kpa and 77°c with a velocity of 50 m/s and exits at 85 kpa and 320 m/s. the heat losses from the nozzle to the surrounding medium at 20°c are estimated to be 3.2 kj/kg. determine (a) the exit temperature and (b) the total entropy change for this process. solve this problem using constant specific heats.

Answers: 1

Answer

You know the right answer?

A solid steel spindle shaft of circular cross section is to be used to support a ball bearing idler...

Questions