subject
Engineering, 06.05.2021 01:50 asdf334asdf334

A 473 V (line-line), 60 Hz, 3 phase, wye connected, 4 pole induction motor is running at rated voltage, speed, and current. The actual machine speed is 1733 rpm. The stator resistance and leakage reactance can be neglected. When the motor runs at no load, with no core losses, the speed is approximately 1800 rpm with a stator line current of 8 A. The rotor resistance referred to the stator R'r is 0.7 Ohm, and the rotor leakage reactance referred to the stator X'ir is 1.6 Ohm. (a) What is the frequency of the rotor currents at this operating point?
(b) What is the rated line current?
(c) What is the starting line current if started at full voltage?
(d) What is the rated torque?

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.
Answers: 1
question
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
question
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
question
Engineering, 04.07.2019 18:20
Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.
Answers: 2
You know the right answer?
A 473 V (line-line), 60 Hz, 3 phase, wye connected, 4 pole induction motor is running at rated volta...
Questions
question
Arts, 27.04.2021 09:30
question
Mathematics, 27.04.2021 09:30
question
Mathematics, 27.04.2021 09:30