Engineering, 05.05.2021 21:00 TamB01
For each of the problems write a CH code to perform the required task. Your program should be
based on the flow chart you drawn in the first worksheet.
1) Receive a number and determine whether it is odd or even
2) Obtain two numbers from the keyboard, and determine and display which (if either) is the
larger of the two numbers,
3) Receive 3 numbers and display them in ascending order from smallest to largest
4) Add the numbers from 1 to 100 and display the sum
5) Add the even numbers between 0 and any positive integer number given by the user
6) Find the average of two numbers given by the user.
I
7) Find the average, maximum, minimum, and sum of three numbers given by the user.
8) Find the area of a circle where the radius is provided by the user.
9) Swap the contents of two variables using a third variable.
10) Swap the content of two variables without using a third variable.
11) Read an integer value from the keyboard and display a message indicating if this
number is odd or even.
12) read 10 integers from the keyboard in the range 0 - 100, and count how many of them are
larger than 50, and display this result​
Answers: 2
Engineering, 03.07.2019 19:30
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
Engineering, 04.07.2019 18:10
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
For each of the problems write a CH code to perform the required task. Your program should be
base...
Mathematics, 05.05.2020 12:26
Biology, 05.05.2020 12:26
English, 05.05.2020 12:26
Biology, 05.05.2020 12:26
History, 05.05.2020 12:26
English, 05.05.2020 12:26
Mathematics, 05.05.2020 12:26
Health, 05.05.2020 12:27
Mathematics, 05.05.2020 12:27