Engineering, 05.05.2021 20:00 mpete1234567890

A venture tube is used to measure the flow rate of a liquid in a pipe (liquid density is 800 kg/m3). The pipe has a diameter of 10 cm and the smallest diameter of the venture has a diameter of 4 cm. A manometer with a manometer fluid of mercury (specific weight of 133 kN/m3) is used to calculate the flow rate which is connected to the venture section such that one leg is far upstream and the second leg is at the minimum diameter of the venture tube. If the flow rate is 0.05 m3/s determine the elevation change in the manometer fluid. a. 14.6 m
b. 9.28 m
c. 4.64 m
d. 2.32 m

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Vibration monitoring this technique uses the noise or vibration created by mechanical equipment and in seme cases by plant systems to detemine their actual condtion. a)- true b)- false

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Plan an experiment to measure the surface tension of a liquid similar to water. if necessary, review the ncfmf video surface tension for ideas. which method would be most suitable for use in an undergraduate laboratory? what experimental precision could be expected?

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Acircular aluminum shaft mounted in a journal is shown. the symmetric clearance gap between the shaft and journal is filled with sae 10w-30 oil at t 30°c. the shaft is caused to turn by the attached mass and cord. develop and solve a differential equation for the angular speed of the shaft as a function of time.

Answers: 2

Answer

You know the right answer?

A venture tube is used to measure the flow rate of a liquid in a pipe (liquid density is 800 kg/m3)....

Questions