Engineering, 01.05.2021 01:30 quynhnguyen7454

The following two DC motors are to be compared for certain application: Motor A: 250 V Shunt motor with 0.2 ohm armature resistance, 125 ohm field resistance, and has a full load operation with 50 armature Amps at 1000 rpm.
Motor B: 250 V Series motor with 0.2 ohm armature resistance, 0.1 ohm field resistance, and has a full load operation with 50 armature Amps at 1000 rpm

Required:
a. While running at full load, what will be the reduction in speed if the load torque is increased by
b. While running at full load, what will be the change in torque if the speed drops by 20%?
c. The added armature starting resistance to start the motor at 200% Of its rated armature current, and what is the corresponding starting torque?
d. What is the starting resistance cut and the motor speed, when the armature current becomes in order to bring the armature current back to the level to continue with its Starting?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)

Answers: 1

Answer

Engineering, 04.07.2019 18:10

True or false (explain) (110)[111] is a slip system in bcc metals . the {111} family in fcc contains 8 planes. resolved shear stress (rss) in single crystals is just related to the applied stress. critical resolved shear stress (crss) in single crystal metals is direct proportional to the number of defects in the structure

Answers: 2

Answer

Engineering, 04.07.2019 18:20

The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?

Answers: 3

Answer

You know the right answer?

The following two DC motors are to be compared for certain application: Motor A: 250 V Shunt motor...

Questions