Engineering, 30.04.2021 20:10 jayloy969

8.65 Consider a thin-walled, metallic tube of length L ϭ 1 m and inside diameter D i ϭ 3 mm. Water enters the tube at m ⅐ ϭ 0.015 kg/s and T m , i ϭ 97 Њ C. (a) What is the outlet temperature of the water if the tube surface temperature is maintained at 27 Њ C? (b) If a 0.5-mm-thick layer of insulation of k ϭ 0.05 W/m ⅐ K is applied to the tube and its outer surface is maintained at 27 Њ C, what is the outlet temperature of the water? (c) If the outer surface of the insulation is no longer maintained at 27 Њ C but is allowed to exchange heat by free convection with ambient air at 27 Њ C, what is the outlet temperature of the water? The free convection heat transfer coefﬁcient is 5 W/m 2 ⅐ K.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

Answer

Engineering, 03.07.2019 15:10

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.

Answers: 1

Answer

You know the right answer?

8.65 Consider a thin-walled, metallic tube of length L ϭ 1 m and inside diameter D i ϭ 3 mm. Water e...

Questions