Engineering, 26.04.2021 21:00 jmitial

Question: A Buck Converter Is Supplied From A 50V Battery Source. Given L=400μH, C=100μF, R=20Ω, F=20KHz And D=0.4 Calculate: (a) Output Voltage (b) Maximum And Minimum Inductor Current, (c) Output Voltage Ripple, (d) What Are The Effects On The Voltage Ripple If The Switching Frequency Is Doubled?A Buck Converter Is Supplied From A 50V Battery Source. Given ... This problem has been solved! See the answer A buck converter is supplied from a 50V battery source. Given L=400μH, C=100μF, R=20Ω, f=20KHz and D=0.4 Calculate: (a) output voltage (b) maximum and minimum inductor current, (c) output voltage ripple, (d) What are the effects on the voltage ripple if the switching frequency is doubled?A buck converter is supplied from a 50V battery source. Given L=400μH, C=100μF, R=20Ω, f=20KHz and D=0.4 Calculate: (a) output voltage (b) maximum and minimum inductor current, (c) output voltage ripple,

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The drive force for diffusion is 7 fick's first law can be used to solve the non-steady state diffusion. a)-true b)-false

Answers: 1

Answer

You know the right answer?

Question: A Buck Converter Is Supplied From A 50V Battery Source. Given L=400μH, C=100μF, R=20Ω, F=2...

Questions