Engineering, 22.04.2021 16:30 shelly30

A servomechanism position control has the plant transfer function G(s) = 10/s(s + 1)(s + 10) You are to design a series compensation transfer function Dc(s) in the unity feedback configuration to meet the following closed-loop specifications The response to a reference step input is to have no more than 16% overshoot. The response to a reference step input is to have a rise time of no more than 0.4 sec. The steady -state error to a unit ramp at the reference input must be less than 0.05. (a) Design a lead compensation that will cause the system to meet the dynamic response specifications, ignoring the error requirement
(b) What is the velocity constant Kv for your design? Does meet the error specification?
(c) Design a lag compensation to be used in series with the lead you have designed to cause the system to meet the steady-state error specification.
(d) Give the Matlab plot of the root locus of your final design.
(e) Give the Matlab response of your final design to a reference step.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency

Answers: 1

Answer

Engineering, 04.07.2019 18:20

For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.

Answers: 1

Answer

You know the right answer?

A servomechanism position control has the plant transfer function G(s) = 10/s(s + 1)(s + 10) You are...

Questions