Engineering, 21.04.2021 19:50 HeycanIto
What's a major difference between a construction drawing and a schematic diagram
Answers: 1
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
Engineering, 04.07.2019 18:10
Which from the following instrument is commonly used to detect the high pitch butzing sound in bearings? [clo4] a)-digital ultrasonic meter b)-infrared camera c)-spectroscopic d)-vibrometer
Answers: 2
What's a major difference between a construction drawing and a schematic diagram...
Mathematics, 26.08.2019 09:30
English, 26.08.2019 09:30
History, 26.08.2019 09:30
Mathematics, 26.08.2019 09:30
Biology, 26.08.2019 09:30
Mathematics, 26.08.2019 09:30
Social Studies, 26.08.2019 09:30
Health, 26.08.2019 09:30
Chemistry, 26.08.2019 09:30
Physics, 26.08.2019 09:30
Mathematics, 26.08.2019 09:30