subject
Engineering, 20.04.2021 14:00 peno211

Assignment # 2 Case Study
Sameer has recently joined a baking factory as a production manager. He observed that the output of staff involved in production is very low as compared to the performance required by them. On analyzing the reasons, he found out that a lot of time of the workers is wasted in getting the required materials issued from the store. Sameer enquired the store keeper reason as to why the material is not issued in time. The store keeper interestingly replied that he receives the demand of certain items which are not available in store. Every day the workers approach him at the last minute to provide different items. If these are not available in the store then he has to place an order with the purchase officer. As a result, a lot of time of the workers is wasted. Sameer felt that there is no harmony in the working of the production department as a whole. So in order to integrate the various production activities, like finance, inventory and purchase, Sameer ensured, that the store keeper is informed three days in advance about the required material, enough finance is available for purchase and consequently, the store keeper is able to keep the materials ready for the workers every morning in accordance with their requirements. Sameer also realized that the workers were not concerned with the achievement of set production targets. Their salary was same for all ranks without considering their skills and experience.

In context of the above case:

1. What was lacking in different production activities
2. Identify and explain the managerial skill used by Sameer to streamline the working of the production department
3. What corrective measure should be taken by Sameer to control the output of the workers

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
question
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
question
Engineering, 04.07.2019 18:10
Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented
Answers: 2
question
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
You know the right answer?
Assignment # 2 Case Study
Sameer has recently joined a baking factory as a production manage...
Questions
question
Biology, 05.02.2021 01:00
question
Mathematics, 05.02.2021 01:00
question
Mathematics, 05.02.2021 01:00
question
Mathematics, 05.02.2021 01:00