Engineering, 20.04.2021 06:10 jose477
When the weld symbol is both above and below the reference line it indicates that a weld is wanted where ?
Answers: 3
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 18:20
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
Engineering, 06.07.2019 03:10
Different between right hand turning tool and left hand turning tool ?
Answers: 1
When the weld symbol is both above and below the reference line it indicates that a weld is wanted w...
Spanish, 28.03.2021 08:00
Mathematics, 28.03.2021 08:00
Mathematics, 28.03.2021 08:00
Spanish, 28.03.2021 08:00
English, 28.03.2021 08:10
Mathematics, 28.03.2021 08:10
History, 28.03.2021 08:10
Chemistry, 28.03.2021 08:10
Mathematics, 28.03.2021 08:10