Engineering, 17.04.2021 19:10 maelaysiap
Two HVAC/R technicians are discussing the soldering of copper pipes. Technician A says that when soldering, it's important to apply flux all the way to the end of the pipe. Technician B says that when soldering, you should twist the pipe inside the fitting to help spread the flux around the joint area. Which one of the following statements is correct?
Answers: 1
Engineering, 04.07.2019 18:10
Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines
Answers: 1
Engineering, 04.07.2019 18:20
Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms
Answers: 2
Engineering, 04.07.2019 18:20
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
Engineering, 04.07.2019 19:10
Asteam is contained in a rigid tank with a volume of 1 m3. initially, the pressure and temperature are 7 bar and 500 oc, respectively. the temperature drops due to cooling process. determine: (1) the temperature at which condensation begins in °c, (2) the fraction of the total mass that has condensed when the pressure decreased to 0.5 bar. (3) the volume in m3 occupied by saturated liquid at the final state?
Answers: 3
Two HVAC/R technicians are discussing the soldering of copper pipes. Technician A says that when sol...
Mathematics, 14.05.2021 06:00
Mathematics, 14.05.2021 06:00
Mathematics, 14.05.2021 06:00
English, 14.05.2021 06:00
Mathematics, 14.05.2021 06:00
Mathematics, 14.05.2021 06:00
Mathematics, 14.05.2021 06:00
Chemistry, 14.05.2021 06:00
English, 14.05.2021 06:00
Mathematics, 14.05.2021 06:00