Engineering, 16.04.2021 19:50 crystal070903

A core-type transformer has a mean magnetic path length of 0.85 m and a cross-section of 0.0066 m^2 . The core is made from silicon sheet steel and has primary and secondary windings with 250 and 750 turns, respectively. A source with a voltage of 240 V (RMS) at 50 Hz. is used to drive the arrangement. When the primary winding is placed across this source, with the secondary open-circuited, the real power drawn is 20 Watts. Answer the following questions about the configuration. Required:
a. Find total exciting current when the 250-turn winding is placed across the source with the secondary open circuited.
b. Find the angle of the exciting current with respect to the source voltage in Part A.
c. Find the source current, in polar form, if the primary winding is connected to the source and a purely resistive load of 1,200 is connected across the secondary winding?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The drive force for diffusion is 7 fick's first law can be used to solve the non-steady state diffusion. a)-true b)-false

Answers: 1

Answer

You know the right answer?

A core-type transformer has a mean magnetic path length of 0.85 m and a cross-section of 0.0066 m^2...

Questions