subject
Engineering, 14.04.2021 19:50 mal5546

How do I draw curves and circles in oblique form? I am in a high school freshman engineering course, and our assignment is to draw three isometric shapes into oblique. However, because we are virtual, it's hard to understand. I need help understanding how to draw an oblique shape with curves and circles.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
question
Engineering, 04.07.2019 18:20
Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k
Answers: 3
question
Engineering, 04.07.2019 18:20
Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?
Answers: 2
question
Engineering, 06.07.2019 02:30
A75mm diameter shaft is supported in a journal bearing 75mm long with a diametral clearance of 0. 1mm. it supports a radial load of 1000 n and is lubricated with sae 50 oil at 70°c. find the friction torque and the power loss when the crankshaft rotates at 2900 rev/min.
Answers: 1
You know the right answer?
How do I draw curves and circles in oblique form? I am in a high school freshman engineering course,...
Questions
question
Biology, 27.09.2021 14:00
question
Mathematics, 27.09.2021 14:00
question
Advanced Placement (AP), 27.09.2021 14:00
question
Chemistry, 27.09.2021 14:00
question
Mathematics, 27.09.2021 14:00