subject
Engineering, 07.04.2021 20:40 ooferson

Problem 1 On a 20°C sunny day with no wind speed, and an air density of 1.2 kg/m², a 1500 kg vehicle travels
along an asphalt roadway with a 6° grade at 100 km/h and a rolling resistance coefficient of 0.013.
The vehicle center of gravity is located 0.6 m from the ground in the center of the 2.5 m wheelbase
with 0.66 m wheels and has a frontal area of 2.05 m² and a drag coefficient of 0.32.
Calculate the aerodynamic, grading, and rolling resistance.
Problem 2
After some engine and transmission performance upgrades, the same vehicle is taken to a test track
to find out the new vehicle top speed. The upgrades have increased engine torque to 450 Nm and
engine horsepower to 300 kW and an overall powertrain efficiency of 88%. After the upgrades, the
minimum gear ratio of the transmission is 0.9, and the differential gear ratio is 3.21.
Calculate the maximum speed of the vehicle
Problem 3
The same vehicle travels along a level asphalt roadway at 100 km/h, with a coefficient of road adhe-
sion of 0.72, and encounters a large obstacle 50 m ahead and needs to stop to avoid striking the
obstacle.
Calculate the braking force at the front and rear wheels that is required to stop just before the
obstacle.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79
Answers: 1
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
question
Engineering, 04.07.2019 19:10
What are the major differences between injection molding and extrusion?
Answers: 2
question
Engineering, 06.07.2019 03:10
Air is flows through an adiabatic nozzle with an inlet pressure of 400 psia at a temperature of 300°f and a velocity of 20 ft/s. the outlet pressure is 40 psia and the velocity is 800 ftl/s. determine the outlet temperature of the air using: a) property tables b) specific heat (using the specific heat value for air at 300°f)
Answers: 3
You know the right answer?
Problem 1 On a 20°C sunny day with no wind speed, and an air density of 1.2 kg/m², a 1500 kg vehicl...
Questions
question
Biology, 20.05.2021 14:00
question
Spanish, 20.05.2021 14:00
question
Mathematics, 20.05.2021 14:00
question
English, 20.05.2021 14:00
question
English, 20.05.2021 14:00
question
Biology, 20.05.2021 14:00