Engineering, 06.04.2021 04:40 sporting06
Tungsten is being used at half its melting point (Tm≈3,400◦C) and astress level of 160 MPa. An engineer suggests increasing the grain size by afactor of 4 as an effective means of reducing the creep rate.(a)Do you agree with the engineer? Why? What if the stress level were equalto 1.6 MPa?(b)What is the predicted increase in length of the specimen after 10,000hours if the initial length is 10 cm?
Answers: 1
Engineering, 04.07.2019 19:20
Air at a pressure of 1atm and a temperature of 40 c is in parallel flow over the top surface of a flat plate that is heated to a uniform temperature of 120 c. the plate has a length of 0.40m (in the flow direction) and a width of 0.15m. the reynolds number based on the plate length is 50, 000. what is the rate of heat transfer from the plate to the air? if the free stream velocity of the air is doubled and the pressure is increased to 10 atm what is the rate of heat transfer?
Answers: 2
Engineering, 04.07.2019 19:20
Acarnot refrigerator operates in a room in which the temperature is 21°c and of power when operating. if the food compartment of the refrigerator is consumes 3 kw to be maintained at 2°c, determine (a) the coefficient of performance of the cycle and (b) the rate of heat removal from the food compartment. refrigerator cycle that has a higher coefficient of performance than that of the discussed (e) is it possible to develop a carn ot refrigerator, operating between the same temperature limits? explain
Answers: 2
Engineering, 06.07.2019 03:20
Figure out the odd statement about ceramics in the following (a) good insulators of heat and electricity (b) usually less desire than metals (c) ductile in nature (d) contains both metallic and nonmetallic elements
Answers: 3
Engineering, 06.07.2019 04:10
Amixture of gases consists of 0.4 kg of oxygen, 0.7 kg of carbon dioxide, and 0.2 kg of helium this mixture is maintained at 100 kpa and 27°c. determine: (a) the apparent molecular weight of this mixture the volume it occupies (b) the partial volume of the oxygen, and (c) (d) the partial pressure of the helium
Answers: 1
Tungsten is being used at half its melting point (Tm≈3,400◦C) and astress level of 160 MPa. An engin...
Mathematics, 02.12.2021 02:20
Mathematics, 02.12.2021 02:20
Computers and Technology, 02.12.2021 02:20
Computers and Technology, 02.12.2021 02:20
Advanced Placement (AP), 02.12.2021 02:20
Spanish, 02.12.2021 02:20
Chemistry, 02.12.2021 02:20
Computers and Technology, 02.12.2021 02:20
Biology, 02.12.2021 02:20
Mathematics, 02.12.2021 02:20
Medicine, 02.12.2021 02:20