subject
Engineering, 05.04.2021 23:50 smilebehappy468

Ethylene hydrogenation The hydrogenation of ethylene to hydrogen is found experimentally to follow the reaction orders given in the following table 341. 270 Chemical Kinetics Rh Catalyst Order in H2Order in CH4 0.85 -0.74 0.95 -0.59 0.55 -0.19 Ru The following steps have been suggested for the catalytic reaction mecha- nism (39. p.53). In this mechanism ethylene adsorbs associatively and H2 adsorbs dissociatively. There is a stepwise addition of adsorbed hydrogen to form an adsorbed ethyl group, C2H5 ads, and then adsorbed ethane, CyH6ynds. CH4 + S C Heads H2 + 25 2Hads C2H4.ads + Heds C2Hs ads +S CH5.ds + Hade C2H6,ads + S CzH6, ads CzH. where Sis a vacant surface site. The rate of the formation of ethane is that of the rate limiting surface hydrogenation step. There are two choices. For Scheme I, the rate limiting step is Reaction 3. For Scheme II, the rate limiting step is Reaction 4. 1. Develop a rate expression for the rate of ethane formation for Scheme 1. Let Reaction 3 be the rate-limiting step and assume all other reactions are at equilibrium. Assume that adsorptionfrom the gas phase follows a Langmuir adsorption isotherm. Neglect the reverse of Reaction 3. When performing a site balance, assume the surface is either vacant or covered with adsorbed ethylene, i. e., the coverage of ethyl, atomic hydrogen and adsorbed ethane are negligibly small 2. Develop a rate expression for the rate of ethane formation for Scheme 11. Let Reaction 4 be the rate-limiting step and assume all other reactions are at equilibrium. Assume that adsorption from the gas phase follows a Langmuir adsorption isotherm Neglect the reverse of Reaction 4. When performing a site balance, assume the surface is either vacant or covered with adsorbed ethylene and ethyl, i. e, the coverage of atomic hydrogen and adsorbed ethane are negligibly small 3. Based on the experimental data listed in the table, is Schemelor ll the more probable mechanism and why?

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:20
Agas mixture consists of 8 kmol of h2 and 2 kmol of n2. determine the mass of each gas and the apparent gas constant of the mixture.
Answers: 3
question
Engineering, 04.07.2019 18:20
Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?
Answers: 3
question
Engineering, 04.07.2019 18:20
Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.
Answers: 2
question
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
You know the right answer?
Ethylene hydrogenation The hydrogenation of ethylene to hydrogen is found experimentally to follow t...
Questions
question
Mathematics, 09.12.2020 07:00
question
Mathematics, 09.12.2020 07:00
question
Mathematics, 09.12.2020 07:00
question
Mathematics, 09.12.2020 07:00
question
Chemistry, 09.12.2020 07:00
question
History, 09.12.2020 07:00