subject
Engineering, 31.03.2021 16:40 brownvester44

Task 1: The surviving group needs a vehicle that will take them over the rough terrain to search for other survivors and to collect data. Requirements:

Needs to travel over rough terrain.

Needs to use a universal joint.

Must be able to switch from two-wheel drive to four-wheel drive.

Task 2: The surviving group needs a machine that will rotate a solar collection dish from inside their labs. The machine must be located outside the building and around the corner.

Requirements:

Needs to have a minimum gear ratio of 1:5 or 5:1.

Must be located around a corner.

Needs to be angled toward the sun.

Must be able to follow the sun.

Task 3: Doctors need a machine to move all of their operating equipment and generators, at one time, from room to room. Some of these rooms are on the second floor, so the machine should be able to traverse both horizontally and vertically. One of the pieces of equipment is an old radio now used to regulate heartbeats, called a cardio regulator.

Requirements:

Must move all of the equipment at once.

Must create a cardio regulator.

The equipment is very heavy. The machine can move slowly, but it must be capable of carrying a lot of weight.

Task 4: For all members to survive, they must have food, water, and shelter. This means pumping water from the ground, cutting wood for building, and grinding grain for flour to eat.

Requirements:

Must create one machine that will perform all three tasks.

Must have only one input to run all devices in order to save energy.

Must be no larger than 10 in. x 10 in.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
question
Engineering, 04.07.2019 18:10
Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery
Answers: 2
question
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
question
Engineering, 04.07.2019 19:10
For a process taking place in a closed system containing gas, the volume and pressure relationship is pvi-constant. -1.5 bar, the process starts with initial conditions, pi = =0.03 m3 and ends with final volume, v2-0.05 m3 determine the work done by the gas.
Answers: 2
You know the right answer?
Task 1: The surviving group needs a vehicle that will take them over the rough terrain to search for...
Questions
question
Biology, 16.07.2019 13:00
question
Mathematics, 16.07.2019 13:00