Engineering, 31.03.2021 03:20 dria40

This problem will take you through the steps needed to calculate the appropriate mass of Tris base, EDTA, and salt (NaCl in this example), and volume of 1 N HCL to use in the preparation of your Tris buffer stck solution for the enzyme kinetics unit. The final volume, concentrations and pH values have been randomized, and are not necessarily the values you have been assigned to use in your stock solution. The formula weight for Tris is 121.1 g/mole, EDTA is 372.2 g/mole, and NaCl is 58.44 g/mole.
Tris base is uncharged (conjugate base), and Tris-HCl has a charge of +1 (conjugate acid).
The pKa' for Tris is 8.2 (use this value in the initial calculation of the Henderson-Hasselbalch equation to determine the CB/CA ratio).
When you solve the final Henderson-Hasselbalch equation to calculate more precisely the amount of HCl to add, use the pKa (8.08) plus your calculated ΔΔpKa.
Provide three significant figures and include units, when appropriate, in your answers
You wish to make 85.0 mL of 158 mM Tris buffer pH 8.20, containing 25.5 mM EDTA and 43.5 mM NaCl.
What mass of Tris base would you need to weigh out?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Vibration monitoring this technique uses the noise or vibration created by mechanical equipment and in seme cases by plant systems to detemine their actual condtion. a)- true b)- false

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

You know the right answer?

This problem will take you through the steps needed to calculate the appropriate mass of Tris base,...

Questions