Engineering, 30.03.2021 18:10 stormserena

A polyamide A-3 flat belt 6 in wide is used to transmit 15 hp under light shock con-ditions where Ks = 1.25, and a factor of safety equal to or greater than 1.1 is appro-priate. The pulley rotational axes are parallel and in the horizontal plane. The shafts loose side is on top. The driven pulley is 18 in in diameter. See Fig. 17-10. The fac-tor of safety is for unquantifiable exigencies. (a) Estimate the centrifugal tension Fc and the torque T.
(b) Estimate the allowable F1, F2, Fi and allowable power Ha.
(c) Estimate the factor of safety. Is it satisfactory ?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Items are similar to the free issue items, but their access is limited. (clo5) a)-bin stock items free issue b)-bin stock controlled issue c)-critical or insurance spares d)-rebuildable spares e)-consumables

Answers: 1

Answer

You know the right answer?

A polyamide A-3 flat belt 6 in wide is used to transmit 15 hp under light shock con-ditions where Ks...

Questions