Engineering, 29.03.2021 18:10 sumitshekhar348
Referring to the figure above, the inside diameter machining marks
A. will be perpendicular to the axis.
B. will be parallel to the axis of the tube.
C. can be no higher than 63 micro-inches in any direction.
D. must be removed after machining​
click on full diagram
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
Engineering, 04.07.2019 18:20
Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k
Answers: 3
Engineering, 04.07.2019 19:10
What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces.a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.
Answers: 1
Engineering, 04.07.2019 19:20
Brief discuss how the presence of dislocations in crystal structures can be an advantage and a disadvantage to engineer and designers.
Answers: 3
Referring to the figure above, the inside diameter machining marks
A. will be perpendicular to the...
Mathematics, 05.07.2020 01:01
Biology, 05.07.2020 01:01
Biology, 05.07.2020 01:01
Biology, 05.07.2020 01:01
Mathematics, 05.07.2020 01:01
Biology, 05.07.2020 01:01
Mathematics, 05.07.2020 01:01
English, 05.07.2020 01:01