Engineering, 24.03.2021 19:00 Decaide

The following data are from the Ohio River in the vicinity of Cincinnati (mile 470) during low flow, September 1967. A. If the mean velocity of the river is 0.3 m s 1, calibrate the Streeter-Phelps model using the field data, and solve for the rate constant ka and kd. The saturation concentration for dissolved oxygen at the time of the survey was 8.3 mg/I, and the main wastewater discharge was at mile point 472. Distance(miles 460 465 470 472 475 480 490 500 510 520 540 560 580
BOD, mall 4 4 4 12 11 9.3 7.5 6 5.3 4.5 4 3 2.5
D. O., ma/l 7.5 7.8 6.7 5.3 3.8 3.2 2.8 2.8 3.1 4.1 5.3 9.3 7.5 6 5.3 4.5 4 2.5
B. waste load allocation. If the flow of the river was 5000 cfs, estimate the wastewater discharge in kg BOD d-1. How much waste is allowed (in kg BOD d-1)if the D. O. Concentration must be greater than 5.0 mg/1?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

How much power could a wind turbine produce if it had the following specifications? cp = 0.45 -d=1.2kg/m3 d=50m v 5m/s

Answers: 2

Answer

Engineering, 04.07.2019 18:20

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

Answer

Engineering, 06.07.2019 03:10

An electrical kettle is made out of stainless steel,weighs two pounds (when empty) with a heating element that consumes 2 kw of electricity. assuming that the water and the kettle are at the same uniform temperature at any moment of time, calculate the shortest possible time to bring 2 quarts of water from room temperature to the onset of boiling.

Answers: 1

Answer

Engineering, 06.07.2019 03:20

What is the maximum height from which a mass of 30 kg can fall on to a flange on the lower end of a vertical rod of length 1.0 m and diameter 20 mm, the upper end being rigidly fixed, if the stress in the rod is not to exceed 80 mpa? the tensile modulus of the rod is 200 gpa.

Answers: 3

Answer

You know the right answer?

The following data are from the Ohio River in the vicinity of Cincinnati (mile 470) during low flow,...

Questions