Engineering, 21.03.2021 06:20 nagwaelbadawi
2. a) Considering how the different phascs are affected during a power system fault, what
are the two main categories of faults in power systems? How are they different?
Which method can be used for analysing them?
b) The single line diagram of a power system is shown in Figure Q2.1 including
generator and transformer winding connection and earthing details. The parameters
for this system have been calculated on a common 100 MVA base and are given in
Table Q2.1. All resistances and shunt susceptances are neglected. This system
experiences a single line to ground fault at a point F on line L1. The point F is at a
distance d from Bus 4 along the line L1. The total length 1 of the line Li is 50 km.
Note that the location of d is not drawn to scale in Figure Q2.1. The fault current at
the fault point F is measured to be 6.106 kA.
G1
3
40
AL
T3
5
L1
-a
(2 d)
يطي
G2
2
T2
Figure Q2.1
Table 02.1
G1
G2
Ti
T2
T3
L1
Rated voltage
(kV)
20
20
20/33
20/33
33/11
11
Zero sequence
Positive sequence Negative sequence
reactance Xo (p. u.) reactance X1 (p. u.) reactance X2 (p. u.)
0.20
0.30
0.35
0.15
0.25
0.30
0.12
0.12
0.12
0.20
0.20
0.20
0.20
0.20
0.20
1.20
0.50
0.50
Answers: 1
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
Engineering, 04.07.2019 18:20
Inadequate stores control is not an obstacle to effective work order system. (clo4) a)-true b)-false
Answers: 3
Engineering, 04.07.2019 18:20
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
Engineering, 04.07.2019 19:10
The proportional limit is always greater than the yield strength for a material. a)-trune b)- false
Answers: 3
2. a) Considering how the different phascs are affected during a power system fault, what
are the t...
Mathematics, 25.07.2019 06:30
Mathematics, 25.07.2019 06:30
History, 25.07.2019 06:30
History, 25.07.2019 06:30
Health, 25.07.2019 06:30
Mathematics, 25.07.2019 06:30
Biology, 25.07.2019 06:30
English, 25.07.2019 06:30