subject
Engineering, 20.03.2021 09:50 amc2412

A tensile specimen with a 12mm initial diameter and 50mm gage length reaches maximum load at 90KN and fractures at 70KN the minimum diameter at fracture is 10mm
determine the engineering stress at maximum load and the true fracture stress.


A tensile specimen with a 12mm initial diameter and 50mm gage length reaches maximum load at 90KN a

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
question
Engineering, 04.07.2019 18:10
An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature
Answers: 2
question
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
question
Engineering, 04.07.2019 18:10
Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery
Answers: 2
You know the right answer?
A tensile specimen with a 12mm initial diameter and 50mm gage length reaches maximum load at 90KN an...
Questions
question
History, 03.05.2020 13:52