Engineering, 19.03.2021 19:20 hannah2718

Consider the compression step of an ordinary vapor compression cycle using ammonia as the working fluid. The inlet to the compressor is saturated vapor at 10 C and approximately 6.25 bar, the outlet is superheated vapor at 10 bar. Approximate the non-ideal PVT-behavior of ammonia in this region by the van der Waalâ€™s EOS. Using the data Tc = 132.4 C, Pc=112.8 bar, and Cv=36.1 kJ/kmol-K (and no other data). Required:
Derive a set of equations that can be solved simultaneously for the temperature of the outlet stream, assuming the compressor is reversible.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

What are the major differences between injection molding and extrusion?

Answers: 2

Answer

You know the right answer?

Consider the compression step of an ordinary vapor compression cycle using ammonia as the working fl...

Questions