subject
Engineering, 19.03.2021 04:50 princessa15266

A sheet of steel 1.5 mm thick has nitrogen (N2) atmospheres on both sides at 1200°C and is permitted to achieve steady-state diffusion condition. The diffusion coefficient for N2 in steel at this temperature is 6 ´ 10-11 m2 /s, and the diffusion flux is found to be 1.2 ´ 10-7 kg/m2 -s. Also, it is known that the concentration of N2 in the steel at the high-pressure surface is 4 kg/m3 . How far into the sheet from the high-pressure side will the concentration be 2.0 kg/m3 ? Assume a linear concentration profile.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
question
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
You know the right answer?
A sheet of steel 1.5 mm thick has nitrogen (N2) atmospheres on both sides at 1200°C and is permitted...
Questions
question
Computers and Technology, 03.12.2021 05:10