Engineering, 18.03.2021 03:30 anika420

Choose the type of alternative energy that you will advocate for. You may choose either a wind farm with an attached plant for generating electricity, or a biomass farm with an attached processing plant for generating biofuel. Choose a location where your farm will be built. You must specify a state in the United States and the approximate location within that state. If you wish, you can choose an actual city or town within your location, or you can invent a hypothetical community.
Design a minimum of 10 slides that you will use in your presentation. The slides can be either created on separate pieces of 8.5" x 11" white paper, or they can be designed using computer software such as PowerPoint. The slides should address why the community was targeted, the science behind the technology, and the benefits to the community; they should also address any concerns that you anticipate the community will have. You don’t have to use references outside of this lesson, but you may do so if you wish. Be sure to cite any outside references on your slides.
Give a 15-minute oral presentation using your slides. Imagine that you are addressing the community in a town hall-style meeting and using your slides to illustrate your points. If you can’t give your presentation to your instructor in person, you may film your presentation.

Upload your slides and your 15-minute presentation that reveal your pitch for alternative energy.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Prove the equivalence between the two statements of the 2nd law of thermodynamics (i.e., a violation of one statement leads to the violatio the other statement)

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

Answer

You know the right answer?

Choose the type of alternative energy that you will advocate for. You may choose either a wind farm...

Questions