Engineering, 18.03.2021 01:30 h0ttmomma92002

A segment of interstate highway requires the construction of an embankment of 350,000 yd3. The embankment fill is to be compacted to a minimum of 90% of the Modified Proctor maximum dry density. A source of suitable borrow material has been located for construction of the embankment and has the following properties: Unit weight 112 pcf Moisture content 9% Swell factor 0.81 Modified Proctor optimum moisture content 12% Modified Proctor maximum dry density 121 pcf Assuming each truck has a maximum capacity of 5.5 yd3, what is the minimum number of truckloads of soil required to construct the embankment using soil from the borrow pit

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Asteam is contained in a rigid tank with a volume of 1 m3. initially, the pressure and temperature are 7 bar and 500 oc, respectively. the temperature drops due to cooling process. determine: (1) the temperature at which condensation begins in °c, (2) the fraction of the total mass that has condensed when the pressure decreased to 0.5 bar. (3) the volume in m3 occupied by saturated liquid at the final state?

Answers: 3

Answer

Engineering, 04.07.2019 19:10

The sum of the normal stresses does not change as the stress state rotates through an angle. a)-trune b)- false

Answers: 2

Answer

You know the right answer?

A segment of interstate highway requires the construction of an embankment of 350,000 yd3. The emban...

Questions