subject
Engineering, 12.03.2021 23:20 krystalhurst97

An angle modulated signal with a sinusoidal carrier 100 cos 2x fet and a sinusoidal message with frequency |--20 Hz, knowing that -0.7
a) Draw the single sided spectrum
b) Determine the modulated signal bandwidth.
c) Determine the 70% and 90% bandwidth and transmitted power.​

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
question
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
question
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
question
Engineering, 04.07.2019 18:10
The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m
Answers: 2
You know the right answer?
An angle modulated signal with a sinusoidal carrier 100 cos 2x fet and a sinusoidal message with fr...
Questions
question
Mathematics, 10.03.2021 09:20
question
Chemistry, 10.03.2021 09:20
question
Mathematics, 10.03.2021 09:20