Engineering, 08.03.2021 19:40 shoobywee

A 300-mm-long, solid, straight shaft is supported in self-aligning bearings at each end. A gear is attached at the middle of the shaft with a 10-mm square steel key in a slot. The geometric stress-concentration factor in the keyslot is 2.5 and its corner radius is 0.5 mm. The gear drives a fluctuating load which creates a bending moment that varies from +10N-m to +100 N-m and a torque that varies from Â–35 N-m to +170 N-m each cycle. The material chosen is cold-drawn 4140 steel, hardened and tempered to Rockwell C45 (Sut = 1250 MPa). Design the shaft for infinite life and determine diameter needed for safety factor of 1.5.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?

Answers: 3

Answer

You know the right answer?

A 300-mm-long, solid, straight shaft is supported in self-aligning bearings at each end. A gear is a...

Questions