subject
Engineering, 08.03.2021 16:10 nicko10

How to measure the quality of the output signal in ADC? A. Signal-to-noise ratio
B. Quantization error
C. Signal-to-quantization-noise ratio
D. Bit error rate​

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.
Answers: 2
question
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
question
Engineering, 04.07.2019 18:20
Select any two (2) areas of applications of chain-drive. (clo4) a)-permanent lubrication necessary b)-hydraulic forklift truck operation c)-rigging and heavy moving materials d)-relatively high maintenance costs e)-costlier than belt drives
Answers: 2
question
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
You know the right answer?
How to measure the quality of the output signal in ADC? A. Signal-to-noise ratio
B. Quantizati...
Questions
question
Mathematics, 03.05.2021 16:50
question
Mathematics, 03.05.2021 16:50
question
Computers and Technology, 03.05.2021 16:50
question
Mathematics, 03.05.2021 16:50