subject
Engineering, 02.03.2021 21:20 bilel2121

B. weight of the structure itself plus the weight added under normal use
c. braces that resist compression
d. usually reinforced concrete shaft at the center of a
building
e forces that act in opposite directions across a material
f. turning force that is applied to a material or structure
g. pulling force that tends to stretch a material
h. crushing force down the axis of a material, resulting in
shortened material
i
agency that builds military and civil works throughout the
United States and the world,

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false
Answers: 2
question
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
question
Engineering, 04.07.2019 18:10
Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines
Answers: 1
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
You know the right answer?
B. weight of the structure itself plus the weight added under normal use
c. braces that resis...
Questions
question
Mathematics, 25.08.2019 05:10
question
Mathematics, 25.08.2019 05:20