Engineering, 02.03.2021 04:10 hudaalkhatib27

4.62 A steady-state, finite-difference analysis has been performed on a cylindrical fin with a diameter of 12 mm and a thermal conductivity of 15W/m K. The convection process is characterized by a fluid temperature of 25°C and a heat transfer coefficient of 25W/m2 K. If the temperature of the first three nodes, separated by a spatial increment of delta x = 10 mm, are T0 =100 degree C, T1 =93.4 degree C, and T2 = 89.5 degree C, determine the fin heat transfer rate. Determine the temperature at the node 3, T3.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

Answer

You know the right answer?

4.62 A steady-state, finite-difference analysis has been performed on a cylindrical fin with a diame...

Questions