Engineering, 02.03.2021 01:00 xxaurorabluexx
I cant talk to this lad without being h0rñy
Answers: 3
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
Agas mixture consists of 8 kmol of h2 and 2 kmol of n2. determine the mass of each gas and the apparent gas constant of the mixture.
Answers: 3
Engineering, 04.07.2019 18:20
Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?
Answers: 2
Engineering, 04.07.2019 18:20
The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?
Answers: 3
I cant talk to this lad without being h0rñy...
Biology, 15.07.2019 13:30
Computers and Technology, 15.07.2019 13:30
History, 15.07.2019 13:30
Mathematics, 15.07.2019 13:30
Physics, 15.07.2019 13:30
Mathematics, 15.07.2019 13:30
Biology, 15.07.2019 13:30
Mathematics, 15.07.2019 13:30
Mathematics, 15.07.2019 13:30
Mathematics, 15.07.2019 13:30
Mathematics, 15.07.2019 13:30
English, 15.07.2019 13:30