subject
Engineering, 01.03.2021 22:20 milkshakegrande101

2. Matlab Simulations (a) Generate 1,000,000 samples of white Gaussian noise of unit variance. The sampling is set as 1 sample/second. Use this as the in-phase. Plot a segment of it over time. Repeat the above for the quadrature. Plot the noise envelope over a segment of time. (b) Consider that you are making a decision every sample, and no signal (target) is present. For the probability of false alarm to 10^-3, what is the false alarm time. The signal bandwidth is the sampling rate

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false
Answers: 2
question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79
Answers: 1
question
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
You know the right answer?
2. Matlab Simulations (a) Generate 1,000,000 samples of white Gaussian noise of unit variance. The s...
Questions
question
Mathematics, 06.05.2020 02:12
question
Chemistry, 06.05.2020 02:12
question
English, 06.05.2020 02:12